Jump to content

Debricker Sa 3Ds Avec Ou Sans Backup De Nand Avec Un Raspberry Py


Recommended Posts

  • Replies 37
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Popular Posts

Voici une video montrant comment debricker sa 3ds sans backup de nand  

qui as une 3ds bricker pour tester (blague) ps: espére personne car avoir une 3ds bricker c'est nul c'est con je hais les brick de 3ds

D'après ce que j'en ai lu c'est pas vraiment un brick mais un lock, il faut faire un unlock de la mémoire du 3DS.   Le logiciel du Raspberry est un logiciel Linux c'est peut-être possible de le faire

Instructions:


1) Extract the linux image.


2) Write the image to the SD card and the USB stick (using win32diskimager for example).


3a) When you use ethernet: check the network settings in the file "interfaces" on the FAT partititon (the one shown on windows) of the USB stick and tweak it to your needs, it's preset to IP 192.168.1.244 and gateway 192.168.1.1.


3b) When you dont use ethernet: rename the update zip file you downloaded earlier to RPU.zip (capital letters do matter) and put it on the USB stick FAT partititon.


4) Plug the SD card and the USB stick into the Pi (doesn't matter which USB port if you've got 2 or use an USB hub).


5) Plug in the other stuff (ethernet or HDMI and USB keyboard) then power it up by plugging in the microUSB.


6) Wait untill it booted (about one minute), if you have hooked it up via HDMI you will see the progress on the screen.


7a) If you are using it via ethernet: ssh into it (you can use putty for that if you are on windows).


8) Log in using root as username and password.


10) Type in 3dsunbrick and press enter. (If you are sure that you are already on the latest version you can skip the update check with 3dsunbrick NOUPDATE)


11) Wait for the tool to update itself and to load.


12) Read the text on the screen.


13) Remove the SD card.


14) Plug in the SDmod card connected to your 3DS and turn the 3DS on.


15) Press s and enter. The tool will try to connect to the 3DS and read it's status. If it shows an error message there are problems with your HW mod or you get interference. Try detaching the charger from your 3DS and powering the Pi from a filtered and stabilized power source (like powering it from an USB port using an USB/microUSB cable).


16) If it reports the MMC to be locked (in other words: it was able to connect to the 3DS and your brick is launcher.dat related) press u and enter.


17) Unless the tool reported an error you should now have an unbricked 3DS.


18) Don't forget to send an erotic cartoon picture to rpu.bkifft.gbatemp@gmail.com and enjoy your unbricked 3DS.
Link to post
Share on other sites

si on peut debriker et donc recharger une nand, pourquoi ne pourrait on pas downgrader par exemple une console ?

Une 3DS XL edition luigi en 4.5 se serait franchement pas mal :thumbup:

Si tu a la nand de la 3DS en question c'est faisable

Link to post
Share on other sites

si on peut debriker et donc recharger une nand, pourquoi ne pourrait on pas downgrader par exemple une console ?

Une 3DS XL edition luigi en 4.5 se serait franchement pas mal :thumbup:

Il est impossible de downgrader une 3ds si tu n'as pas le firmware de ta console (unique) en 4.5

La méthode citée plus haut ne permet que de réparer les degas subit par le brick de la memoire nand.

Effectivement on peut recharger un firmware à la seule condition d'avoir fait un backup avant de la console

Link to post
Share on other sites

Bonjour à tous,

De mon côté, j'ai réussi à débricker une 3DS (les menus étaient inaccessibles), en faisant un court-circuit avec la batterie.

La batterie était totalement chargée, la coque arrière démontée, j'ai remis la batterie sans la coque et bougé latéralement et doucement, le led bleu est passé du bleu au rouge, ensuite un message d'erreur de Nintendo est venu sur l'écran, "le système doit être rebooté suite à une erreur". Après le reboot, la 3DS est revenu à un état normal

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...



×
×
  • Create New...